International Coatings 108 Glow-in-the-Dark Plastisol Ink
IC-108
Glow-in-the-Dark (phosphorescent) is a plastisol screen printing ink that produces a bright, greenish glow when exposed to light and viewed in a darken area.
FEATURES
108 Glow-in-the-Dark can be used for direct print or cold peel transfer applications.
108 Glow-in-the-Dark is ready for use straight from the container.
INK APPLICATION
Direct Prints: 108 Glow-in-the-Dark ink should be used right from the container without any modifications. If thinning is required, use 1% to 5% by volume of 1110 Curable Reducer. Adding too much reducer or other additives will diminish opacity and glow.
Transfers (cold peel): It is important that the inks are only partially gelled, otherwise the inks will not have adequate adhesion during the final transfer application.
IMPORTANT INFORMATION
108 Glow-in-the-Dark is not a low bleed ink. Always test print the fabric to be printed before beginning production. It is best to do some long term testing on fabrics to determine if they are going to bleed. Bleeding or dye migration may not occur right away.
108 Glow-in-the-Dark is a very transparent ink and works best when printed on white fabric or over a white base.
Do not fuse or cure the ink at too high a temperature (over 330°F or 166°C) as the phosphorescent pigment used in the ink can be damaged and not glow properly.
Adding too much reducer, soft hand additive or clear base will diminish glow. STIR the ink prior to printing on press and after addition of reducers or additives.
Heavier ink deposits of 108 Glow-in-the-Dark will result in increased phosphorescence (glow brightness) and a longer glow after exposure to a bright light source. Depending on the amount of light exposure to the ink, the darkness of the of the area where the ink is being viewed and the eye sensitivity of the person viewing the ink, the glow may be visible anywhere from 15 minutes up to two hours.
When making cold peel transfers for dark fabrics, back transfers with white ink. Cold peel transfers should be applied at 350°F to 375°F (177°C to 191°C), medium pressure (40 lbs.) for 10 to 15 seconds.
Test dryer temperatures and wash test printed product before and during a production run.
RECOMMENDED FABRICS
100% Cotton
Some Cotton/Polyester Blends
SCREEN MESH
60-230 t/in (24-90t/cm) monofilament
SQUEEGEE
65-75 Durometer Sharp edge
CURE TEMPERATURES
325ºF (163ºC) for 1 minute dependent on dryer speed and temperature settings
STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC)Avoid storage in direct sunlightKeep containers well sealed
Feel free to live chat with us if you have any questions.